How to restart the Systam X self-service kiosk

If the kiosk is not working as it should, or the building's network has been changed, a restart often helps. This guide shows two ways to restart Systam X.

Guides for other kiosks: Systam Lite and Table-X.

Quickest way: unplug the power cable

Unplug the kiosk's power cable from the wall, wait about 10 seconds and plug it back in. The kiosk starts up and is ready to use again in a moment.

Restart with the power button

There are two versions of Systam X, and the power button is in a different place on each. Check the pictures to see which one you have.

Systam X with an external camera

The power button is on the back of the display, about 7 cm from the right edge towards the center. The power indicator light is at the same spot on the bottom edge. The button is round and slightly concave. Hold it down for a moment so the device registers the press.

Systam X with a built-in camera

The power button is on the back of the display. It is the button closest to the right edge. Hold it down for a moment so the device registers the press.

If the kiosk does not restart, contact our support at support@systam.fi.

All set, your kiosk is ready for visitors again.